Quick test of the AF tube amplifier module

Following my recent post on the small AF tube amplifier module that I have built for my next regenerative receiver, please find below a short video showing a quick test of the amplifier using my PC as the audio source.

My next regen receiver - The AF amplifier

After some time from my last post on the subject of my next homebrew regen receiver (that post was about the power supply), I can finally make a little step forward by adding some information about the AF amplifier module.
The design has been entirely copied from the Jon Fleig's Pipsqueak guitar amplifier (here it is the original schematic diagram), with a few little modifications to component values, based on what I had at hand.

Here below I add some pictures of my build of the circuit above. The construction is all but elegant, however results of initial tests seem encouraging.
I expect to get an output power of less that 1 W on a 8 ohms load, more than enough to drive a small loudspeaker for my receiver. I plan to post a video of how it sounds actually quite soon.